Bell System bell free Uživatelský manuál stáhnout pdf (Strana 46)

Bellﬁ res

English

Instructions for use and installation instructions

5 FAULTS

Possible reasons for the gas ﬁ re going out are:

• The concentric ﬂ ue system is not installed according to one of the methods detailed

in Paragraph 3.4

• An incorrect “ﬂ ue gas restriction plate” is ﬁ tted.

• The pilot light extinguishes if fumes are not exhausted or are insufﬁ ciently

exhausted.

• The pilot light is either dirty or defective.

• Insufﬁ cient gas pressure.

• Thermocouple voltage is too low. This is usually caused by insufﬁ cient heating of

the thermocouple by the pilot light.

• Dirty electrical contacts in the thermo-electrical system; for example, the

thermocouple connection.

• Batteries in receiver or remote control are ﬂ at.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 55 56

Žádné komentáře

Bell System bell free Uživatelský manuál Strana 46