Bell System BL106 Uživatelský manuál stáhnout pdf (Strana 28)

CS106/BL106 Combined Door Entry and Coded Access

Commissioning

After installation of the C106 unit, follow the two test procedures below; any

problems can be diagnosed from the troubleshooting section. Finally program

the required security and access codes (page 16).

Testing the Lock Release Outputs

Ensure that the lock release is connected to the correct output (as shown in the

Wiring diagram on page 9).

Press and hold the C106 Keypad TEST button:

•

Both of the Lock Outputs

(Fail-Safe and

Fail-Secure) and both

red and green LEDs will

illuminate.

• After 5 seconds the LEDs

will start to alternate and

the lock output will stop

operating; you should

release the test button at

this stage to avoid

programming the factory

settings (see page 32).

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Žádné komentáře

Bell System BL106 Uživatelský manuál Strana 28