Bell System BL106 Uživatelský manuál stáhnout pdf (Strana 32)

CS106/BL106 Combined Door Entry and Coded Access

Programming the Factory Settings with the Test Button

In the event of any problems, always return to Factory Settings. If the security

key has been forgotten, the test button can be used to restore factory settings.

In the case of a fault disconnect the lock release, before following this

procedure.

This operation will restore all codes, times and functions to the factory settings

(see Table 1 page 25 for the complete list).

This facility is useful for fault diagnosis. It makes use of the Test Button on the

C106 Keypad. It is always advisable to return to this condition whenever the

unit appears to malfunction during installation or following an unsuccessful

programming session.

program Factory Settings

 Press and hold the TEST

button.

 Observe the red and green

LEDs come on (5 seconds)





 Observe the red and green

LEDs alternating (3

seconds)







Finally the red and green LEDs will flash together for 1 seconds

and extinguish. The Factory Settings are now restored; release

the TEST button.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Žádné komentáře

Bell System BL106 Uživatelský manuál Strana 32